I happened upon some release notes for IOS v 15.2 which mentioned that IOS now supports TWAMP. A little extra digging also shows that support extends to IOS XE v 3.6S.
This is good news for us because we were likely going to have to deploy shadow routers with our Juniper kit, something none of us was looking forward too. That said, we're not out of the woods yet because IOS XR doesn't appear to have TWAMP support yet and that's what much of our core runs.
Certainly progress in the right direction though. When I get a chance to run it up, i'll post configs here.
This is good news for us because we were likely going to have to deploy shadow routers with our Juniper kit, something none of us was looking forward too. That said, we're not out of the woods yet because IOS XR doesn't appear to have TWAMP support yet and that's what much of our core runs.
Certainly progress in the right direction though. When I get a chance to run it up, i'll post configs here.
hi,
ReplyDeletewas looking at integrating juniper and cisco h/w using TWAMP on 15.1 however could not get much support, have you check with 15.2 and Juniper 12.x series what results you get.